Skip to Content
Repair
Vaillant Fault codes Vaillant

ecoTEC VCW /5-5

101 codes. Choose a code: what it means and what you can do.

Sometimes a number follows the code (6A 227): type it too, the page shows what it means.

F.00 Flow temperature sensor disconnected
F.01 Return temperature sensor disconnected
F.02 Hot water sensor disconnected
F.03 Cylinder temperature sensor disconnected
F.10 Flow temperature sensor short circuit
F.11 Return temperature sensor short circuit
F.12 Hot water sensor short circuit
F.13 Cylinder temperature sensor short circuit
F.20 Overheat safety device tripped
F.22 Not enough water or water pressure too low
F.23 Flow-return temperature difference too large
F.24 Temperature rising too fast
F.25 Flue gas temperature too high
F.26 Gas valve fault
F.27 Flame detected with the burner off
F.28 Ignition failure at start-up
F.29 Flame lost during operation, relighting failed
F.32 Fan not running correctly
F.42 Coding resistor fault
F.49 eBUS line fault (controls)
F.52 Mass flow sensor not connected
F.53 Gas flow outside expected values
F.54 Gas pressure too low at start-up
F.55 CO sensor fault
F.56 Safety shutdown: CO limit exceeded
F.57 Combustion control fault
F.61 Gas valve control fault
F.62 Delayed gas valve shut-off
F.63 Circuit board memory (EEPROM) fault
F.64 Electronics or sensor fault
F.65 Electronics temperature too high
F.67 Implausible flame signal
F.68 Unstable flame signal
F.70 Invalid appliance identification
F.71 Flow sensor stuck on one value
F.72 Flow and return sensor mismatch
F.73 Water pressure sensor: signal too low
F.74 Water pressure sensor: signal too high
F.75 Pump fault or lack of water
F.77 Flue gas flap or condensate pump fault
F.78 Accessory or control module misconfigured
F.80 Storage tank inlet sensor fault
F.81 Storage tank charging failed
F.82 Impressed current anode fault
F.83 Temperature does not rise at burner start
F.84 Implausible flow-return temperature difference
F.85 Flow and return sensors wrongly fitted
F.90 Communication with the tank module lost
F.91 Storage module sensor fault
F.92 Gas type setting not valid
F.93 Combustion quality out of range
F.94 Vortex sensor fault

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.