Water pressure sensor: signal too low
Breakdown: the boiler is stopped
The water pressure sensor sends a signal that is too low or no signal at all: sensor, cable or plug broken or short-circuited, on a boiler as on an aroTHERM, versoTHERM plus or recoCOMPACT exclusive heat pump (heating circuit sensor); on the ecoTEC plus /5-5, ecoTEC pro /5-3 and ecoVIT VKK /4 boilers it can also report a water pressure that is too low. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service; the heat pump no longer works normally and, depending on the fault, may keep running in emergency mode.
What you can do
- Write down the code shown and the boiler or heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.73?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a recognised installer
Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.
The variants of code F.73
The meaning depends on the boiler: find yours below.
Error: water pressure sensor
Sensor fault: heating circ. water pressure
Water pressure sensor signal in incorrect range (too low)
Water pressure sensor fault (signal too low)
Water pressure sensor signal in an unsuitable range (pressure too low)
Water pressure sensor fault
Water pressure sensor short circuit
Water pressure sensor signal in an incorrect range (too low)
The boilers that show this code
What our technician checks
- The system water pressure
- The sensor wiring harness, plug and earth connection (break, short circuit)
- The water pressure sensor, replaced if faulty