Skip to Content
Repair
Buderus Fault code Buderus
5239

Hot water sensor TW1 fault

Breakdown: the boiler is stopped

On a Logatherm WLW176i or WLW186i heat pump (BC400 control), the hot water sensor TW1 has a fault: a short circuit or fault on the sensor or its cable, or a faulty XCU-HY board. This is an alarm: our technician has to find the cause.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 5239?

Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 5239

The meaning depends on the boiler: find yours below.

5239

DHW temperature sensor TW1 fault

Breakdown: the boiler is stopped BC400

What our technician checks

  • Sensor TW1 disconnected from the XCU-HY board, its resistance checked against the sensor table, then the cable or the sensor
  • The XCU-HY board, replaced if the sensor is fine and the fault stays

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

H01

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.