Skip to Content
Repair
Buderus Fault code Buderus
1010

No communication with the controller (EMS bus)

Blocking: it retries by itself

The boiler, or a Logatherm WLW176i or WLW186i heat pump (BC400 control), no longer receives any communication over the EMS bus, the link to the heating controller and the connected modules. The cause: a wiring error, the bus cable or a faulty device connected to the bus.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 1010?

Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 1010

The meaning depends on the boiler: find yours below.

1010

No communication via the EMS BUS connection

Blocking: it retries by itself BC400, GB172i.2, GB182i.2, GB192i.2, GB272

The boilers that show this code

What our technician checks

  • The EMS bus wiring, then switching the controller off and on again
  • The bus cable, repaired or replaced
  • The faulty device connected to the bus, replaced
  • The bus extension modules, removed to see whether the module or its wiring is the cause (heat pump)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

A11

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.