Water pressure too low
Blocking: it retries by itself
The water pressure in the heating system is too low, on the boiler as on a Logatherm WLW176i or WLW186i heat pump (BC400 control). The boiler keeps running, but water needs to be added; on the heat pump, the system has to be filled to the right pressure, the one given in its installation manual.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
- Do you often have to add water? Let us know: there is probably a leak or a faulty expansion vessel.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show 1017?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 1017
The meaning depends on the boiler: find yours below.
Water pressure too low
The operating pressure is low
The boilers that show this code
What our technician checks
- Filling to 2 bar and venting the system
- Leaks in the system and the expansion vessel
- The pressure sensor and its wiring, replaced if needed
- The system pressure on the gauge, and filling to the pressure in the installation manual (heat pump)