Water flow too low in the boiler
Blocking: it retries by itself
The water flow through the heat exchanger is too low. This is not a lockout: the boiler starts again by itself as soon as the cause is gone.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check that enough radiators are open.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show 2964?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 2964
The meaning depends on the boiler: find yours below.
Flow rate too low in the heat exchanger
The boilers that show this code
What our technician checks
- The proper operation of the heating circuit
- The pump settings, adapted to the system
- The connectors on the temperature sensor and the control unit
- The fastening of the temperature sensor
- The sensor and its connection cable, replaced if necessary