282
No feedback signal from the pump
Information: nothing to do
The heating pump (circulator) is not sending the boiler information about its speed, or is not receiving a control signal. Depending on the model, this is just a message or a fault that locks out the boiler.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Nothing to do
This message belongs to the boiler's normal operation.
Call usChoose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 282
The meaning depends on the boiler: find yours below.
282
No speed feedback from the pump
Information: nothing to do
GB192i
The boilers that show this code
What our technician checks
- The wiring and operation of the circulator; replaced if necessary