Skip to Content
Repair
Buderus Fault code Buderus
1021

Domestic hot water sensor faulty

Blocking: it retries by itself

The boiler reports a fault in a temperature sensor of the domestic hot water (DHW) cylinder (charging sensor, hot water sensor or cold water sensor, depending on the model). This is a service message: the boiler keeps running, sometimes with limited functions, but a repair is needed.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 1021?

Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 1021

The meaning depends on the boiler: find yours below.

1021

The cylinder charging or DHW temperature sensor is faulty

Blocking: it retries by itself GB172i.2, GB182i.2
1021

Stratification cylinder cold water temperature sensor faulty

Blocking: it retries by itself GB192i

The boilers that show this code

What our technician checks

  • The connectors on the sensor and on the control unit, and the sensor mounting
  • The sensor, measured with an ohmmeter, and its cable; replaced or repaired if needed
  • Switching the appliance off and on again (GB192i)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.