Heating water too hot (over 105 °C)
Breakdown: the boiler is stopped
The flow sensor measures heating water above 105 °C. For safety, the boiler locks out and only restarts after a reset.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 218?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 218
The meaning depends on the boiler: find yours below.
The temperature measured by the flow temperature sensor is higher than 105 °C
The boilers that show this code
What our technician checks
- The water pressure, and venting of the appliance and the system
- The water flow rate in the system
- The pump and the flow sensor, replaced if needed