210
Flue gas temperature too high
Information: nothing to do
The flue gas temperature sensor measured a temperature that was too high and opened. On the GB192i, the boiler reports this as an operating message; on the GB162 (1C 210), it is a locking fault that requires a reset.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Nothing to do
This message belongs to the boiler's normal operation.
Call usChoose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 210
The meaning depends on the boiler: find yours below.
210
The temperature measured by the flue gas temperature sensor is too high; as a result it…
Information: nothing to do
GB192i
The boilers that show this code
What our technician checks
- The operation of the flue gas temperature sensor, replaced if needed
- Fouling of the appliance, serviced if needed