No communication between display and circuit board
Breakdown: the boiler is stopped
The boiler's display and circuit board no longer communicate: the connecting cable, the display or the board is at fault. The boiler goes into fault mode and stops until the cause is fixed and it is reset. On a 230 V flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, F.707 likewise reports that the display is not detected: the connecting cable is not connected or wrongly connected, or the control panel display is faulty; here too, our technician fixes it and puts the heat pump back into operation.
What you can do
- Write down the code shown and the boiler or heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.707?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a recognised installer
Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.
The variants of code F.707
The meaning depends on the boiler: find yours below.
Communication between the display and the PCB is not possible.
no communication between the electronics and the control element
Connection fault: display not detected
What our technician checks
- The connection between display and circuit board
- The cable between display and circuit board, replaced if needed
- The display or the circuit board, replaced if needed