No flame after ignition
Breakdown: the boiler is stopped
On recent boilers, the same problem as 6A: ignition has taken place, but no flame is detected. The boiler shuts down for safety.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check that the boiler's gas shutoff valve is open.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 227?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 227
The meaning depends on the boiler: find yours below.
No flame signal after ignition
Insufficient flame formation (ionisation current) during the burner ignition attempt
The boilers that show this code
What our technician checks
- The gas shutoff valves (main and appliance)
- The gas line and the gas pressure
- The burner adjustment: CO2 content and air/gas ratio
- Grounding, ignition and ionization current
- The electrodes, their cables and connectors
- The condensate drain and fouling of the heat exchanger on the flue gas side
- The gas valve and the burner control unit, replaced if needed