Skip to Content
Buderus Fault code Buderus
208

Chimney sweep mode (flue gas test)

Information: nothing to do

The boiler is heating for a flue gas test: this is chimney sweep mode, used for the technician's measurements, and on several models it stops by itself after 15 minutes. This is a normal operating message: there is nothing to do.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 208

The meaning depends on the boiler: find yours below.

208

Heat demand due to flue gas test

Information: nothing to do GB172i.2, GB182i.2, GB192i.2, GB272
208

The appliance is in chimney-sweep or service mode

Information: nothing to do GB192i

The boilers that show this code

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

-A

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.