Skip to Content
Repair
Viessmann Fault code Viessmann
F.87

System water pressure too high

Breakdown: the boiler is stopped

The water pressure in the heating system is too high. The burner goes into fault: the boiler stops heating and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F.87?

Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.87

The meaning depends on the boiler: find yours below.

F.87

System overpressure

Breakdown: the boiler is stopped Vitodens One Base

What our technician checks

  • Lowering the pressure to the permitted value (drain and refill if the message returns after 10 s)
  • The system pressure, measured with an external gauge
  • The expansion vessel and its pre-charge, replaced if needed
  • The water pressure sensor: connection and deviation from an external gauge (above 10 %, replaced)
  • Blockages of the non-return valves
  • The safety group, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.