Skip to Content
Repair
Viessmann Fault code Viessmann
F5

Air pressure switch or flow sensor fault

Breakdown: the boiler is stopped

On a Vitopend 100-W WH1D and a Vitodens 200 WB2A, the air pressure switch, which monitors the air intake and the flue, does not react as expected when the burner starts: the burner locks out and the boiler only starts again after a reset; on a Vitodens 100-W WB1A the air pressure switch is faulty and the burner stays blocked until it is repaired. On a Vitodens One Base (200-W B2HF or B2KF, 222-F B2TF, 222-W B2LF), F.5 means a fault in the water flow sensor: the boiler keeps running normally, on a substitute value.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Vitopend 100-W WH1D and Vitodens 200 WB2A only: reset the boiler once only.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F5?

Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F5

The meaning depends on the boiler: find yours below.

F.5

open circuit of the flow rate sensor

Blocking: it retries by itself Vitodens One Base
F5

The air pressure switch does not open when the burner starts or does not close when the…

Breakdown: the boiler is stopped Vitopend 100-W WH1D
F5

Air pressure switch faulty

Blocking: it retries by itself Vitodens 100-W WB1A
F5

The air pressure switch is not open when the burner starts

Breakdown: the boiler is stopped Vitodens 200 WB2A

What our technician checks

  • Vitopend 100-W WH1D: the flue and air intake duct
  • The air pressure switch, its hoses and connecting cables
  • Vitodens 200 WB2A: the fan, its connecting cables, its power supply and its control
  • Vitodens One Base: plug 33/X6 and the cable between the BCU burner control unit and the flow sensor
  • Vitodens One Base: the flow sensor, replaced if the message persists, then the BCU burner control unit

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.