Heating pump dry or without pressure
Breakdown: the boiler is stopped
The heating pump is running dry (older Cerapur, A1 shown alone) or builds no pressure in the circuit (Cerapur ZWB and ZSB ..-4C, A1 with 281): the cause is the water pressure, air in the system, a closed valve or the pump itself. On the older Cerapur the boiler goes into fault until it is reset; on the Cerapur ..-4C it is a blocking fault: it stops and restarts by itself as soon as the cause is gone.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check the water pressure on the gauge: normally between 1 and 2 bar (between 1 and 1.5 bar on an older Cerapur). Too low? Top up while the boiler is cold, as your installer showed you.
- Older Cerapur, A1 shown alone (no number next to it): reset the boiler once only.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show A1?
Repair visit: 360 € excl. VAT (381.60 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Junkers is a brand of the Bosch group: Ecowatt is a Bosch Qualified Partner, an installer recognised by Bosch.
The variants of code A1
The small number shown beside the code tells which.
Heating pump running dry
The heating pump does not generate any pressure
The boilers that show this code
What our technician checks
- The system water pressure, topped up and purged if needed
- The isolating valves, to be opened
- Purging the boiler (service function 2.2C)
- The heating pump: get it running, replace if needed